Your Cart

Bear Cat CH8540 PTO Chipper Attachment 8"

Bear Cat CH8540 PTO Chipper Attachment 8"
Sold Out
Bear Cat CH8540 PTO Chipper Attachment 8"
  • Availability: Sold Out
  • Model: CH8540 PTO Chipper Attachment 8"
Product Views: 16804
California Proposition 69 Warning
Warning: This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.

Power take off on utility tractors have become a primary source for much of the work around farms, orchards, golf courses, etc. Any place where you need to turn a pile of branches into a pile of chips.

You choose - self feed or hydrostatic hydraulic feed for infinite feed settings - these chippers mount on your three point hitch and hook directly to the PTO for quick setup and power on demand.

Rotating 360 degrees, the 8 inch round discharge chute gives you accurate control over the flow of chips produced. The 30 x 1 inch thick, 275 pound dynamically-balanced disc, adjustable 4-sided anvil, four reversible chipper blades. The feed roller on Model CH9540H is 15 inches in diameter, containing 10 knife blades for enhanced powerful feeding. A hydraulic jack is mounted on the hydraulic feed system for ease of maintenance. Plate steel construction means solid performance for hundreds of hours, and maintenance is enhanced by a hinged disc cover that provides wide open access to the chipper blades and disc.

(*NOTE - For Use On Tractors with PTO Horsepower Ratings From 35 hp to 60 hp)


Chipper Capacity (in)
up to 8
Chipper Capacity (in)
L x W x H (in)
54 x 47 x 93
Weight (lbs)
Chipper Disc
30 x 1.25/275 lbs., rotates at 1,500 rpm
Feed Opening
9 x 9
Feed System
Gravity/Self Feed
Chipper Chute Opening (in)
30 x 31
Chipper Blades
4 reversible heat treated steel chipper blades with 4 sided adjustable anvil
Rotor Weight (lbs)
PTO HP Required
35-60 HP
PTO Capable
Drive Belt
Power sourcePTO

Write a review

Note: HTML is not translated!
Bad Good